- 1 How do I sync my Harbor Breeze remote to my fan?
- 2 What is the blue wire on a Harbor Breeze ceiling fan?
- 3 How do I reset my Harbor Breeze remote without reset button?
- 4 How do you sync a ceiling fan remote?
- 5 Can black and blue wires go together?
- 6 What do I do with the red wire when installing a ceiling fan with remote?
- 7 How do I reset my Harbor Breeze remote?
- 8 Where do I get the harbor Breeze fan manual?
- 9 How do you remove globe from Harbor Breeze ceiling fan?
- 10 Do you need a harbor Breeze ceiling fan?
How do I sync my Harbor Breeze remote to my fan?
Replace the remote battery and battery compartment cover. Restore the electricity to your Harbor Breeze fan by flipping the appropriate circuit breaker switch back to the “On” position. Press the “Hi,” “Med” and “Lo” buttons on the remote control within 20 seconds to synchronize it to the fan.
What is the blue wire on a Harbor Breeze ceiling fan?
The blue wire on a ceiling fan is to control the power running to the light kit. The black wire is usually reserved for fan power only and does not extend over to your light kit. Without connecting the blue wire on your ceiling fan to a power source, you will not be able to control your lights.
First turn off the device, then turn it back on and, within 30 seconds of turning it on, press and hold the fan button for 10 seconds. This will restore it.
How do you sync a ceiling fan remote?
Turn the power to your fan off for 5-10 seconds and then back on using the wall switch. Quickly press the ‘PAIR’ button on the back of the remote control. This step should be done within three minutes of restoring power to the fan. Your fan should turn on low speed indicating the pairing was successful.
Can black and blue wires go together?
Twist a yellow wire connector to all three wires. If you have the additional toggle switch, connect the two black wires together with an orange wire connector, and then match the blue wire and the red wire together. Twist another orange wire connector on the red and blue wires.
What do I do with the red wire when installing a ceiling fan with remote?
The red wire is the ungrounded (hot wire) conductor of one switch, while the black wire is the ungrounded (hot wire) conductor of the other switch. One switch would energize the red wire in the original installation, causing the fan to turn on. The other is responsible for the black wire to turn on the light.
How do I reset my Harbor Breeze remote?
To reset your Harbor Breeze ceiling fan remote you need to turn the power off then on and then push the ‘reset’ button or ‘learn’ button under the back cover of the remote. Make sure you hold the reset button down until the light comes on and the ceiling fan speed goes to medium.
Where do I get the harbor Breeze fan manual?
Full Harbor Breeze Ceiling Fan manuals come with each new ceiling fan purchased. Check your box the fan came in. If you don’t have the box the ceiling fan came in and you threw your manual away like me, then you may contact Lowe’s directly request a new manual be sent to you.
How do you remove globe from Harbor Breeze ceiling fan?
Gently hold the fan globe in one hand while you work with a screwdriver to get it off the fan. Be careful not to drop the globe as it is highly breakable. If there are no screws on the globe, you probably just need to gently turn it to one side to unscrew it.
Do you need a harbor Breeze ceiling fan?
Harbor Breeze are a great ceiling fan to have for the indoors as they are very good at moving large volumes of air around your home. Especially crucial for those hot summers! If you are looking for easy installation advice, tips and guides then please keep reading.