Contents
How much does it cost to have something waterjet cut?
A: Water jet cutting cost per hour is between $15 and $40. The price depends on various factors, including the type of materials, size of the material, material thickness, etc.
Is laser cutting cheaper than water jet?
Plasma operating cost would again be the lowest, and is typically estimated at approximately $15/hour. The cost of laser would be slightly higher, typically estimated at around $20/hour. Waterjet is usually considered to be the most expensive, typically estimated at about $30/hour.
What are the disadvantages of water jet cutting?
Disadvantages of Waterjet Cutting
- Cutting Time – While the waterjet cutter can cut most of the same materials, very often the cutting takes longer than a traditional cutter.
- Orifice Failure – Low quality waterjet orifices have a tendency to break down and disrupt cutting, resulting in lost time and productivity.
What is the cost of water jetting?
On average, hydro jetting services can run anywhere from $300 to upwards of $500, depending on the severity of the blockage, the location of the clog in the drain or line, and even the area in which you live. In some more extreme cases, a complicated job could cost you as much as $1,000 at some plumbing services!
How thick of material can a waterjet cut?
Truly, a waterjet can cut up to any thickness, but tolerances will change the thicker the material being cut. Tight accuracies can be kept when cutting materials under 4 inches thick, a near net shape is achieved when cutting thicker materials.
How accurate is water jet cutting?
What is the Base Accuracy of the Waterjet Cutting Process? Relatively speaking, a water jet cutting process is highly accurate. Once the cutting starts (meaning that the initial through hole is complete), a waterjet cutting machine can achieve a parts tolerance of +/- 0.001” with consistency.
Can you engrave with a water jet?
A laser cutting machine can engrave as well as cut material, while waterjet only allows cutting. Laser engraving is an advantage if you want to directly add serial numbers, assembly marks, or simply aesthetic designs.
What tolerance can a water jet hold?
Accuracy. Flow waterjets can make parts to very tight tolerances, some systems can create parts with a tolerance as close as 0.001″ (0.025 mm). For waterjet cutting, typical part tolerances range from between 0.003″ and 0.005″ of an inch.
Can you make money with a waterjet?
Modern machine controls for waterjet cutting allow you to switch between making a single part slowly at low cost or more quickly at a higher cost. When the machine is fully loaded, it is often, but not always, more profitable to make the same parts faster, even at a higher cost. …